Choosing Diversity Antenna Mode During Registration
You may now carry out any other adjustments to the HSUs from the HBS or by direct
connection. Notice that we adjusted the Tx Power for all elements in the sector to keep the
RSS at a reasonable level.
As a partial alternative method, you may enter the HSU Name and Location fields during
Registration.
If you do not see the changes as shown, a hard reset of the HSUs will cause
them to appear.
Note
Choosing Diversity Antenna Mode During
Registration
Suppose that in Figure
6‐10 for HFU.10.101 we had chosen Diversity mode, the outcome
would look like this:
The assured throughput in both directions on this HSU has dropped to about half of its
previous value. (The Rx and Tx rates drop slightly. The reason that there is no significant
change to the Rx and Tx rates is that the SBM mechanism is allocating additional time slots in
both directions. See Chapter 10 for details about the operation of SBM.) The other HSUs are
left unchanged.
This underlines the flexibility of the RADWIN 5000 system which enables HSUs to be
independently configured depending on their particular location.
Deactivating the HBS
From the HBS button bar, click the right hand button followed by Deactivate.
RADWIN 5000 HPMP User Manual
Release 3.5.70
6‐35