Configuring Aes 256 Encryption Support - Radwin 5000 HPMP User Manual

Configuring AES 256 Encryption Support
A few minutes later, you should receive an email, containing in its body, a list of
license keys.
You may see error messages in the Status Column such as Band not
supported or Serial not found. Supported bands typically reflect your local
regulations. Check missing serial numbers with RADWIN Customer Service.
Note
7. Copy and Paste the license keys into a plain text file and save it to a safe known place.
8. Open the Configure | Operations tab (Figure
navigate to the file you saved in the last step.
9. Click Activate. The next time you enter the Change Bands tab, the new bands will be
available.
Configuring AES 256 Encryption Support
AES 256 support is per HSU but enabled from the HBS.

To enable AES 256 Encryption support for a sector:
1. Ensure that the HBS is hardware ready for AES 256: From the HBS Configuration but‐
ton, open the Inventory page and check that the hardware version is 9 or higher.
Open a text file and copy/paste the serial number of the HBS to it.
2. Determine which HSUs require AES 256 support. From the Inventory page for each
HSU, check that the hardware version is 9 or higher. Copy/paste the serial number of
the HSU to the text list, one serial number per line. Alternatively, use the capture
button in list mode at the HBS to copy paste a list of HSUs.
In any event, you must still check the hardware level of each listed HSU.
3. Save the text file and send it to your equipment supplier with your license purchase
order.
4. You will receive by return email a text attachment showing serial number and license
key. Save the file to a known safe location.
5. At the HBS, open the Configuration | Operations tab (Figure
File button and navigate to the file you saved in the last step.
RADWIN 5000 HPMP User Manual
8‐16). Check the License File button and
Release 3.5.70
8‐16). Check the License
8‐54