Radwin 5000 HPMP User Manual page 368

Spectrum View Main Window: HBS
Use the top left panel to set the Spectrum View configuration parameters and choose an
analysis type ‐ Entire Sector or Specific HSU.
The settings are "sticky" for the HBS and will be reused. The analysis range is limited from
4900 to 6050 MHz with a maximum difference of 500MHz. Erroneous entries will be shown
with a red border like this:
The timeout is the maximum analysis time per site. Use the bottom button bar to start an
analysis, to stop a running analysis or run a Highest Interference profile for the sector:
If you choose to run the analysis for specific HSUs, The left hand HSU panel will change:
RADWIN 5000 HPMP User Manual Release 3.5.70 24‐3