Radwin 5000 HPMP User Manual page 187

Configuration Menu Buttons
The Backup and Restore buttons have the same functionality as the corresponding buttons
for the HBS. They provide for backup and restore of the HSU software.
A backup (full or configuration) may be restored top another HSU provided
that the product IDs and revision levels of the source and target HSUs are
identical.
In addition, the capacity and supported bands must be the same for the
Note
source and restored HSUs.
The Buzzer button may set or mute the buzzer.
The Auto position means that the Buzzer will give the beeps shown in Figure
installation or upon sync loss.
The Advanced Auto position means that in addition, the buzzer will beep continuously at
different rates upon sync loss, antenna mis‐alignment and other events for up to two minutes
following restoration of sync.
Recall that the main use of the buzzer tone is for HSU antenna alignment.
The Refresh button restores the current window to its previous state abandoning any changes
you made, provided that you did not click Apply or OK.
We will work through each of the Configuration tabs in turn:
RADWIN 5000 HPMP User Manual Release 3.5.70
4‐38 during
8‐32