Private MIB Parameters
Table C‐3: Private MIB Parameters ‐ HSU (Sheet 6 of 33)
Name
winlink1000OduAirRxPower
winlink1000OduAirTotalFrames
winlink1000OduAirBadFrames
winlink1000OduAirCurrentRate
winlink1000OduAirCurrentRateIdx
winlink1000OduAirChainsRxPower
winlink1000OduAirTxPower36
winlink1000OduAirTxPower48
winlink1000OduAirCurrentTxPower 1.3.6.1.4.1.4458.1000.1.5.1
winlink1000OduAirMinFrequency
winlink1000OduAirMaxFrequency
winlink1000OduAirFreqResolution
winlink1000OduAirCurrentFreq
winlink1000OduAirNumberOfChan
nels
winlink1000OduAirChannelsTable
winlink1000OduAirChannelsEntry
winlink1000OduAirChannelsIndex
winlink1000OduAirChannelsFreque
ncy
winlink1000OduAirChannelsOperSt
ate
winlink1000OduAirChannelsAvail
winlink1000OduAirChannelsDefault
Freq
RADWIN 5000 HPMP User Manual
OID
Type
1.3.6.1.4.1.4458.1000.1.5.9.
Integer
1
1.3.6.1.4.1.4458.1000.1.5.9.
Counter
2
1.3.6.1.4.1.4458.1000.1.5.9.
Counter
3
1.3.6.1.4.1.4458.1000.1.5.9.
Integer
4
1.3.6.1.4.1.4458.1000.1.5.9.
Integer
5
1.3.6.1.4.1.4458.1000.1.5.9.
OctetString
6
1.3.6.1.4.1.4458.1000.1.5.1
Integer
0
1.3.6.1.4.1.4458.1000.1.5.1
Integer
1
Integer
2
1.3.6.1.4.1.4458.1000.1.5.1
Integer
3
1.3.6.1.4.1.4458.1000.1.5.1
Integer
4
1.3.6.1.4.1.4458.1000.1.5.1
Integer
5
1.3.6.1.4.1.4458.1000.1.5.1
Integer
6
1.3.6.1.4.1.4458.1000.1.5.1
Integer
7
Release 3.5.70
Description
RO
Received Signal Strength in dBm. Relevant only
for point to point systems.
RO
Total number of radio frames.
RO
Total number of received radio frames with CRC
error. The value is relevant only for point to
point systems .
RO
Deprecated parameter. Actual rate of the air
interface in Mbps. For Channel Bandwidth of
20 10 5 MHz divide the value by 1 2 4
respectively.
RO
Index of current air rate.
RO
Received Signal Strength of Cpe chains in dBm.
Chain 1 RSS: (1 Byte) Chain 2 RSS: (1 Byte)
Chain 3 RSS: (1 Byte)
RW Deprecated parameter. Actual behavior is read‐
only.
RW Deprecated parameter. Actual behavior is read‐
only.
RO
Current Transmit Power in dBm. This is a
nominal value while the actual transmit power
includes additional attenuation.
RO
Minimum center frequency in MHz.
RO
Maximum center frequency in MHz.
RO
Center Frequency resolution. Measured in
MHz if value < 100 otherwise in KHz.
RO
Current Center Frequency. Measured in MHz if
center frequency resolution value < 100
otherwise in KHz.
RO
Number of channels that can be used.
N/A Table of channels used by automatic channels
selection (ACS).
N/A ACS channels table entry. INDEX {
winlink1000OduAirChannelsIndex }
RO
Channel Index.
RO
Channel frequency in MHz.
RW Channel state. Can be set by the user.
Automatic Channel Selection uses channels that
are AirChannelsOperState enabled and
AirChannelsAvail enabled. A change is
effective after link re‐synchronization. Valid
values: disabled (0) enabled (1). Rewriteable
only in Point‐To‐Point products.
RO
Channel state. Product specific and cannot be
changed by the user. Automatic Channel
Selection uses channels that are
AirChannelsOperState enabled and
AirChannelsAvail enabled. Valid values:
disabled (0) enabled (1).
RO
Default channel's availability for all CBWs. The
valid values are: forbidden (0) available (1).
C‐44