Radwin 5000 HPMP User Manual page 347

Setting up the HBS for QoS
1. The required queues for the sector and their respective priority mappings must be chosen.
2. For each HSU you must configure the required queues, queue weights and queue Maxi‐
mum Information Rate (MIR). The latter must be done for both the Uplink and Downlink
directions.
Setting up the HBS for QoS
From the HBS manager, enter Configuration, open the Ethernet tab and then QoS
configuration. QoS is disabled by default. You may choose between the VLAN (802.1p) and
Diffserv methods.
The default settings for Diffserv and VLAN are as shown in the next two figures:
RADWIN 5000 HPMP User Manual Release 3.5.70 21‐2