Which Type Of Hss To Use - Radwin 5000 HPMP User Manual

RFP: General Radio Frame Pattern
Table 13‐3: Legend for Radio Frame Pattern Tables
Item Description
Best fit Optimal RFP choice for TDM and Ethernet services
Available Available RFP for TDM and Ethernet services, but not optima
N/A Service unavailable
Select the RFP that gives you the Best Fit or Available for required system services and select
the channel bandwidth accordingly.
The RFP must be the same for each link within the collocated system.
Note
RFP: General Radio Frame Pattern
When setting the RPF, the following considerations should be borne in mind:
• When synchronizing RADWIN 5000 HBS units you must use RFP E
• When synchronizing RADWIN 5000 HBS with RADWIN 2000 or WinLink 1000 units you
must use RFP E
• RFP influences capacity and latency.
• Using the Link Budget Calculator, you can see the effect of the RFP on the Ethernet
throughput.
Which Type of HSS to Use
You may use both forms of HSS with the HBS. There are however some limitations:
• If you collocate an HBS to both a unit supporting SHSS and HSSoE, the HBS must always
be HSM
• If you collocate with a GSU, you can only use HSSoE and the GSU mast be HSM.
RADWIN 5000 HPMP User Manual Release 3.5.70 13‐5