Configuring A Fixed Hsu From The Hbs - Radwin 5000 HPMP User Manual

Configuring a fixed HSU From the HBS
Figure 6‐4: Activated HBS recognizing installed but unconfigured HSUs
If there are too many HSUs for the Table view, switch to the scrollable List view.
13. If you are using Local Connection, log out and log back in to the HBS on its IP
address.
At this point, you are able to configure the HSUs for service.
You may have observed that operating frequency 5.735 GHz shown, is not what we chose
(5.820 GHz). The HBS tries to optimize the frequency to minimize interference effects.
We next configure and register the HSUs. For fixed HSUs you can do this in either order. For
nomadic HSUs you must define the HSU as Nomadic prior to registration. We will show the
method below. Our preference is to carry out configuration first for all HSUs.
Configuring a fixed HSU From the HBS
The HSU activities described in this section, may be carried out any time ‐ regardless of
whether or not the HSU is registered for service or not. These activities include among other
things, setting the Location, Contact, Name and IP address.
The procedures in this section should be carried out for each fixed HSU in the sector.
RADWIN 5000 HPMP User Manual Release 3.5.70 6‐20