Configuration of VLAN Tagging for Ethernet Service
3. Enter a Provider VLAN ID and Priority. The VLAN ID must be in the range 2 to 4094.
The VLAN Priority must be in the range 0 to 7. You may also change the TPID from
the default as shown.
This facility is provided to enable connection through legacy switches
requiring it. Otherwise, there is no need to change the TPID.
Note
4. Click OK to accept.
5. For user VLAN tagging, click the Tag Radio button:
In Tag mode Ethernet frames are tagged or untagged to distinguish between differ‐
ent networks.
6. For completely transparent passage of tagged frames, there is nothing further to do.
The following table shows the possible settings for each combination of Ingress and
Egress modes:
RADWIN 5000 HPMP User Manual
Release 3.5.70
18‐9