Radwin 5000 HPMP User Manual page 165

Management
The VLAN priority is used for the traffic sent from the ODU to the managing com‐
puter.
4. Change the VLAN ID and Priority of the managing computer NIC to be the same as
those of steps 2 and 3 respectively.
5. Click Apply or OK.
Lost or forgotten VLAN ID
If the VLAN ID is forgotten or there is no VLAN traffic connected to the ODU, then reset the
relevant ODU.
During the first two minutes of connection, the ODU uses management packets both with
and without VLAN. You may use this period to reconfigure the VLAN ID and priority.
Supported Protocols
Supported protocols are shown in Figure
Figure 8‐2: Supported protocols
SNMP support is permanently enabled. You may choose between SNMPv1, SNMPv3 or both.
If you choose SNMPv3, you will be offered the following cautionary message:
For a sector managed as part of a network, direct access to a HBS/HSU using Telnet is
considered to be a security breach. Telnet access may be enabled or disabled by clicking the
Protocol tab and enabling/disabling Telnet access using the Telnet check‐box. Similar
considerations apply to access via the Web Interface.
• For further details about Telnet access see page
• For further details about the Web Interface, see Chapter 25.
Telnet and Web Interface access modes when available, are site specific. If for example, you
want Telnet access from specific sector members, you should enable it for these sites and
disable it elsewhere.
RADWIN 5000 HPMP User Manual
8‐2:
8‐56.
Release 3.5.70 8‐10