Interface Api; Private Mib Structure - Radwin 5000 HPMP User Manual

Interface API
Interface API
Control Method
The RADWIN Manager application provides all the means to configure and monitor a
RADWIN 5000 HPMP link, communicating with the SNMP agent in each ODU. Each SNMP
agent contains data on each of the PoEs and ODUs in the link. Both agents communicate with
each other over the air using a proprietary protocol.
Each ODU has a single MAC address and a single IP address.
Note
To control and configure the device using the MIB, you should adhere to the following rules:
• The connection for control and configuration is to the local site, over any SNMP/UDP/IP
network.
• All Parameters should be consistent between both of the ODUs. Note that inconsistency
of air parameters can break the air connection. To correct air parameters inconsistency
you must reconfigure each of the ODUs.
• Common practice is to configure the remote site first and then to configure the local
site.
• For some of the configuration parameters additional action must be taken before the
new value is loaded. Please refer to the operation in the parameters description.
• Some of the MIB parameters values are product dependent. It is strongly recommend
using the RADWIN Manager Application for changing these values. Setting wrong values
may cause indeterminate results.
Community String
To control a link, all SNMP requests should go to the local site IP address.
See Table 5‐6 for default Community strings.
Private MIB Structure
The sections in the private RADWIN MIB and its location in the MIB tree are shown in
Figure C‐1 below:
RADWIN 5000 HPMP User Manual Release 3.5.70 C‐2