Figure 12-7 Setting The Upper - Radwin 5000 HPMP User Manual

HBS
Figure 12‐7: Setting the upper traffic threshold
To get data for display, click Get Data. The process may take a few seconds.
Here is an extract Performance Monitoring report based on 15 minutes recording:
Figure 12‐8: HBS ‐ Performance Monitoring report ‐ Valid data
The meaning of the column headings is shown in the following table:
Table 12‐2: HBS Performance Monitoring Fields
Abbreviation
Column Heading
Meaning
Integrity Valid data flag
Date & Time Time stamp
Unavailable
UAS
Seconds
ES Errored seconds
Severe Errored
SES
Seconds
RADWIN 5000 HPMP User Manual
Description
Green tick for current and valid; Red cross for
invalidated data (See example below). Note that the
Performance Monitoring data is not valid if not all the
values were stored (e.g., due to clock changes within
the interval or power up reset)
Data are recorded every 15 minutes; the last 30 days
of recordings are maintained. Roll‐over is at midnight.
Seconds in which the interface was out of service.
The number of seconds in which there was at least
one error block.
The number of seconds in which the service quality
was low as determined by the BBER threshold.
Release 3.5.70 12‐11