Figure 15-2 Extended Protocol; Figure 15-3 Hss Discovery - Radwin 5000 HPMP User Manual

Configuring the HBS as an HSM
Figure 15‐2: Extended Protocol Parameters for HSSoE
4. Leave the Operation state as is at Hub Sync Master. Here is the full range of options:
Later, we will need one of the client options for the collocated site.
5. The Protocol should be left as is at Ethernet. (For the moment, there are no other
options.)
6. The Domain is the HSS domain and refers to the current hub site. It is used to
distinguish between hub sites to prevent inadvertent collocation to an over‐the‐air
unit. We set it as shown, to PM_Lab.
7. Leave the VLAN ID as is at 1977 unless there is some reason to change it.
8. The Discovery options are as follows:
Figure 15‐3: HSS discovery filters
9. Choose All. In our case it will show the HBS as HSM and the collocated ODU as HSC:
RADWIN 5000 HPMP User Manual Release 3.5.70 15‐5