Radwin 5000 HPMP User Manual page 75

Getting Started with the RADWIN Manager
Table 5‐5: Preconfigured setup - one nomadic HSU
Location Attribute
Address
IPv4
Net Mask
Default Gateway
Address
IPv6 Subnet Prefix Length
Default Gateway
HNU.01.01
Protocol
Contact
Name
Time Slots
Unit Serial Number
We have add place‐holders for a further three nomadic HSUs. That is, up to four vehicles
equipped to work in this way, may operate simultaneously in the sector.
Choose your unit locations carefully. For example, for three collocated HBSs
each with 32 HSUs covering 360°, matters get out of hand very quickly if
units are poorly named. They can always be identified by their IP addresses,
but that is a poor substitute for effective naming. A URL‐like naming pattern
based on HBS_n.HSU_y is clear and familiar to all Internet users. Keeping
Tip
the names IP address independent enables you to copy the entire sector
setup to a different geographic location without IP address duplication.

To start the RADWIN Manager:
1. Connect the managing computer to the HBS PoE LAN port.
2. Check that you have connectivity to the HBS. You can do this by opening up a
command line session (Start|Run and then type, cmd). At the command prompt,
type
ping 10.104.50.200
You should see something like this:
RADWIN 5000 HPMP User Manual
Value
10.104.50.3
255.255.0.0
10.104.10.21
2005:104:50::3
32
2005:104:20::21
SNMPv1
Brahms
Brahms@HNU.01.01
Downlink 6
Uplink 2
P07030E000A0003B
Release 3.5.70
Remark
All communicating HSUs and HBS in
the same subnet
Can be set to SNMPv3 or both v1
Optional
Location of Contact ‐ optional
May vary with context
5‐6