Radwin 5000 HPMP User Manual page 348

Setting up an HSU for QoS
If you un‐check a queue, it will be disabled for the sector. It will not prevent the HSU from
configuring it as "live". The purpose behind this is to avoid the necessity of reconfiguring QoS
for each HSU, should the queue be reinstated.
Setting up an HSU for QoS
QoS setup for an HSU is carried out from the HBS.

To configure an HSU for QoS:
1. Right click an HSU in the HBS manager HSU window, and choose Configuration.
2. Open the Ethernet tab and click QoS Configuration. The following window is
displayed:
3. Ensure that the Mode field is Enabled. If you already configured the HBS (sector) for
Diffserv or VLAN, then it will be enabled by default. If you need to change the mode,
then you probably did not set the sector wide QoS type ‐ but you can go back and do
it later.
RADWIN 5000 HPMP User Manual Release 3.5.70 21‐3