Configuring Receive And Transmit Signaling - HP FlexNetwork MSR Series Configuration Manual

Step
1. Enter system view.
2. Enter digital E&M voice subscriber
line view.
3. Enable E&M non-signaling mode.

Configuring receive and transmit signaling

The ABCD bit pattern of the receive idle signal from the local end must be the same as that of the
transmit idle signal from the remote end. Seized signals and idle signals are processed in the same
way.
To configure receive and transmit signaling:
Step
1. Enter system view.
2. Enter E1/T1 interface view.
3. Create a TS set for digital
E&M signaling and select a
start mode.
4. Exit E1/T1 interface view.
5. Enter digital E&M voice
subscriber line view.
6. Configure the ABCD bit
pattern of receive idle signal.
7. Configure the ABCD bit
pattern of receive seized
signal.
8. Configure the ABCD bit
pattern of transmit idle
signal.
9. Configure the ABCD bit
pattern of transmit seized
signal.
IMPORTANT:
After you change the ABCD bit pattern of a digital E&M signal, shut down the digital E&M voice
subscriber line with the shutdown command and then bring the line up with the undo shutdown
command. Otherwise, the voice subscriber line cannot work correctly.
Command
system-view
subscriber-line slot-number:
ts-set-number
open-trunk { caller monitor
interval | called }
Command
system-view
controller { e1 | t1 } slot-number
timeslot-set ts-set-number
timeslot-list timeslots-list signal
{ e&m-delay | e&m-immediate |
e&m-wink }
quit
subscriber-line
slot-number:ts-set-number
signal-value received idle ABCD
signal-value received seize ABCD
signal-value transmit idle ABCD
signal-value transmit seize ABCD
85
Remarks
N/A
N/A
Optional.
Disabled by default.
For more information about the
open-trunk command, see
HPE FlexNetwork MSR Router
Series Comware 5 Voice
Command Reference.
Remarks
N/A
N/A
N/A
N/A
N/A
Optional.
The default is 1101.
Optional.
The default is 0101.
Optional.
The default is 1101.
Optional.
The default is 0101.