Configuring Udp Or Tcp For Incoming Sip Calls - HP FlexNetwork MSR Series Configuration Manual

Configuring UDP or TCP for incoming SIP calls

Configuration prerequisites
If a SIP server is used to forward calls, you need to complete the configuration at the SIP server end.
Configuration procedure
To specify UDP or TCP as the transport layer protocol for incoming SIP calls:
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP client view.
4. Specify UDP or TCP as the
transport layer protocol for
incoming SIP calls.
Configuring SIP security
This section describes how to configure TLS for outgoing SIP calls and media flow protocols for SIP
calls.
Configuring TLS for SIP sessions
Configuration prerequisites
•
If a SIP server is used to forward calls, you need to complete the configurations on the SIP
server.
•
Configure an SSL policy on the device. To make sure that the certificate on the device can be
used, be sure that the device system time falls within the validity time of the certificate.
Configuration procedure
To reference the SSL policy:
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP client view.
4. Reference the SSL policy for
the client.
5. Reference the SSL policy for
the server.
To specify TLS as the global transport layer protocol for outgoing SIP calls:
Command
system-view
voice-setup
sip
listen transport { tcp | udp }
Command
system-view
voice-setup
sip
crypto ssl-client-policy
client-policy-name
crypto ssl-server-policy
server-policy-name
149
Remarks
N/A
N/A
N/A
Optional.
By default, both the UDP and TCP
listening ports are enabled.
Remarks
N/A
N/A
N/A
Not configured by default.
Not configured by default.
For more information about SSL
policies, see HPE FlexNetwork
MSR Router Series Comware 5
Security Configuration Guide.