Configuring Match Order Of Voice Entity Selection Rules; Configuration Prerequisites; Configuration Procedure - HP FlexNetwork MSR Series Configuration Manual

[RouterA-voice-dial] number-match longest
After you dial number 20001234 at Telephone A and waits for a period of time (during this
period, you can continue dialing), the number matches VoIP entity 2000 and Telephone B is
alerted. If you continue to dial 1234 during this period (that is, the dialed number is actually
200012341234), the number matches VoIP entity 2001 and Telephone C is alerted.
•
Dial terminator
# Configure the longest match mode and the dial terminator # on Router A. The other steps are
the same as those for the shortest match mode.
[RouterA-voice-dial] number-match longest
[RouterA-voice-dial] terminator #
After you dial 20001234# at Telephone A, the number immediately matches VoIP entity 2000
and Telephone B is alerted.
Configuring match order of voice entity selection
rules
If multiple voice entities can match a call number, the voice gateway follows the configured rules to
select a proper voice entity.
The match order is as follows:
1. Voice entity type selection priority rule—This rule means that different priorities are
configured for different types of voice entities (VoIP, POTS, VoFR and IVR). The voice gateway
matches a voice entity according to the priorities of different types of voice entities.
2. Match order of voice entity selection rules—These rules cover exact match, priority, random
selection, and longest idle time. For more information, see HPE FlexNetwork MSR Router
Series Comware 5 Voice Command Reference. You can select one to three rules to form a
sequence. The voice gateway will first select a voice entity according to the first rule. If the voice
gateway fails to decide which number should be selected according to the first rule, it will apply
the second rule, and so on.

Configuration prerequisites

The required basic configurations have been completed on POTS, VoIP, VoFR, and IVR entities.

Configuration procedure

To configure voice entity selection priority rules:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter voice entity view.
5. Configure the voice entity
priority.
6. Exit voice entity view.
Command
system-view
voice-setup
dial-program
entity entity-number { pots | ivr |
vofr | voip }
priority priority-order
quit
108
Remarks
N/A
N/A
N/A
N/A
Optional.
0 by default.
N/A