Rebooting A Voice Card; Configuration Guidelines; Configuration Procedure - HP FlexNetwork MSR Series Configuration Manual

Configuration restrictions and guidelines
•
This function is supported on E&M cards only. You must specify an E&M card when you
configure this function.
•
This function takes effect only when G.711 A-Law is used.
•
You must reboot the specified card after you configure this function. To check whether this
function takes effect, use the display device verbose command.

Configuration procedure

To configure the PCM pass-through function:
Step
1. Enter system view.
2. Enter voice view.
3. Enable the PCM
pass-through function.

Rebooting a voice card

Rebooting a voice card initializes the card and interrupts all traffic on it. You can reboot a voice card
when it fails (for example, the configuration is correct but no call connection can be established). The
reboot process is indicated by the LED.

Configuration guidelines

•
The vi-card reboot command reboot analog voice cards (including FXS, FXO, and E&M),
SIC-AUDIO, and BSV.
•
The SIC digital voice cards and VE1 and VT1 voice cards cannot be rebooted by using
commands.
•
FIC analog voice cards can also be rebooted by using the reboot slot slot-number command.
For more information about the reboot slot command, see HPE FlexNetwork MSR Router
Series Comware 5 Fundamentals Command Reference.
Configuration procedure
To reboot a card:
Step
1. Reset the voice card in user
view.
2. Enter system view.
3. Enter voice view.
4. Reboot a voice card.
Command
system-view
voice-setup
pcm-passthrough slot
slot-number
Command
reboot slot slot-number
system-view
voice-setup
vi-card reboot slot-number
53
Remarks
N/A
N/A
Optional.
By default, the PCM pass-through
function is disabled.
Remarks
Optional.
N/A
N/A
Optional.