HP FlexNetwork MSR Series Configuration Manual page 349

Step
1. Enter system view.
2. Enter voice view.
3. Enter voice AAA client
view.
4. Configure a rule for
saving CDRs.
Configuring an access number
Two-stage dialing users must dial a specific access number before making an IP call. Therefore,
configure corresponding access numbers on the voice gateway before providing the two-stage
dialing service to end-users. You can configure up to 100 access numbers on a voice gateway.
Configuration prerequisites
A voice interface card (for example, an FXS interface card) is inserted in the router.
Configuration procedure
To configure an access number:
Step
1. Enter system view.
2. Enter voice view.
3. Enter dial program view.
4. Configure an access number
or enter access number
view.
Configuring two-stage dialing process
An access number itself is only a code for a dialing process. You need to configure a series of
attribute parameters to form a complete dialing process.
There are three types of the two-stage dialing process: caller number process (calling number
authentication), caller number process with IVR (calling number authentication), and card
number/password process (card number/password authentication). Therefore, it is necessary to
specify a dialing process for each access number. When a dialing process is switched to another
dialing process, the default parameters are restored.
Differences between the caller number process and the caller number process with IVR are as
follows:
•
In the caller number process, after a user dials an access number, the voice gateway plays only
dial tones (long tones).
•
In the caller number process with IVR, a user can select a language in which prompt tones are
played. After the user selects a language, the voice gateway plays tones in the selected
language to prompt for a called number.
Configuration prerequisites
You have configured an access number.
Command
system-view
voice-setup
aaa-client
cdr { buffer size-number |
duration timer-length |
threshold percentage }
Command
system-view
voice-setup
dial-program
gw-access-number
access-number
336
Remarks
N/A
N/A
N/A
The default is 50 for the size-number
argument, 86,400 seconds (namely, 24
hours) for the timer-length argument, and
80 for the percentage argument.
Remarks
N/A
N/A
N/A
No access number by default.