E1 Voice Dss1 Signaling Configuration Example - HP FlexNetwork MSR Series Configuration Manual

# Associate the POTS voice entity with FXS subscriber line 1/1:1.
[RouterB-voice-dial-entity2001] line 1/1:1
[RouterB-voice-dial-entity2001] send-number all
[RouterB-voice-dial-entity2001] quit
# Create a POTS voice entity corresponding to telephone number 0755-2002 for the E1
interface.
[RouterB-voice-dial] entity 2002 pots
# Configure a target match-template for the POTS voice entity.
[RouterB-voice-dial-entity2002] match-template 07552002
# Associate the POTS voice entity with subscriber line 1/1:1.
[RouterB-voice-dial-entity2002] line 1/1:1
[RouterB-voice-dial-entity2002] send-number all
[RouterB-voice-dial-entity2002] quit
# Create a VoIP voice entity.
[RouterB-voice-dial] entity 010 voip
# Configure a target match-template for the VoIP voice entity.
[RouterB-voice-dial-entity10] match-template 010....
# Configure the target address of the VoIP voice entity.
[RouterB-voice-dial-entity10] address ip 1.1.1.1

E1 voice DSS1 signaling configuration example

Network requirements
As shown in
routers (Router A and Router B) across an IP network.
•
In City A, Router is connected to a PBX through an E1 subscriber line, and to the telephone at
0101003 through an FXS voice subscriber line.
•
In City B, Router B is connected only to a PBX through an E1 subscriber line.
The two routers communicate with their respective PBX by exchanging DSS1 user signaling through
an ISDN interface. One-stage dialing mode is configured on the two routers.
Figure 24 Network diagram
Configuration procedure
1. Configure Router A:
# Configure the IP address 1.1.1.1/24 for the interface Ethernet 2/1.
<RouterA> system-view
[RouterA] interface ethernet 2/1
Figure 24, Telephones in City A and City B communicate with each other through voice
94