Call Node Configuration Example 4: Extension Secondary Call - HP FlexNetwork MSR Series Configuration Manual

Call node configuration example 4: extension secondary call

Network requirements
As shown in
Router B.
•
After the subscriber originates a call through a SIP server by dialing 300 (the IVR access
number of Router B) from Telephone A, Router B plays the audio file welcome.wav. After the
subscriber dials 0 at Telephone A to originate a secondary call, Telephone B rings.
•
If the subscriber dials a wrong number at Telephone A, Router B plays the audio file
input_error.wav.
•
If the timeout value expires before the subscriber dials at Telephone A, Router B plays the audio
file timeout.wav.
Figure 94 Network diagram
Configuration procedure
1. Configure Router A:
# Configure POTS voice entity 100.
<RouterA> system-view
[RouterA] voice-setup
[RouterA-voice] dial-program
[RouterA-voice-dial] entity 100 pots
[RouterA-voice-dial-entity100] match-template 100
[RouterA-voice-dial-entity100] line 1/0
[RouterA-voice-dial-entity100] quit
# Configure VoIP voice entity 300 to Router B.
[RouterA-voice-dial] entity 300 voip
[RouterA-voice-dial-entity300] match-template 300
[RouterA-voice-dial-entity300] address sip ip 1.1.1.2
[RouterA-voice-dial-entity300] outband sip
2. Configure Router B:
# Configure POTS voice entity 500.
<RouterB> system-view
[RouterB] voice-setup
[RouterB-voice] dial-program
[RouterB-voice-dial] entity 500 pots
[RouterB-voice-dial-entity500] match-template 500
[RouterB-voice-dial-entity500] line 1/0
[RouterB-voice-dial-entity500] quit
# Configure IVR voice entity 300 and specify node 10 as the root node.
[RouterB-voice-dial] entity 300 ivr
[RouterB-voice-dial-entity300] match-template 300
Figure 94, configure the IVR access number and customize Call node functions on
297