Configuring Mwi - HP FlexNetwork MSR Series Configuration Manual

Configuring MWI

This section describes configuration procedures for enabling, disabling, displaying, and maintaining
MWI.
Configuration prerequisites
The router is equipped with an FXS voice interface card.
Enabling and disabling MWI
Configure MWI using command lines to enable or disable the feature, and to set the message
waiting tone duration.
To configure MWI:
Step
1. Enter system view.
2. Enter voice subscriber line
view.
3. Enable MWI.
4. Configure the duration of
message waiting tone.
Specifying the voice mailbox server
The voice gateway sends a SUBSCRIBE to the server, and receives a NOTIFY from the server if the
subscription is successful, and gets the status of the voice mailbox afterwards.
To specify the voice mailbox server:
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP client view.
4. Specify the voice mailbox
server.
Command
system-view
subscriber-line line-number
mwi enable
mwi tone-duration length
Command
system-view
voice-setup
sip
mwi-server { dns domain-name |
ipv4 ip-address } [ expires
seconds ] [ port port-number ]
[ retry seconds ] [ tcp | tls ]
[ scheme { sip | sips } ] { bind |
no-bind { loose | strict } }
241
Remarks
N/A
N/A
Disabled by default.
Optional.
The default is 2 seconds.
Remarks
N/A
N/A
N/A
Not specified by default.