Configuring Hunt Group Priority Level - HP FlexNetwork MSR Series Configuration Manual

Step
3. Enable hunt group for the
voice subscriber line.
NOTE:
To use the hunt group feature, you need to configure the hunt-group enable command on all
involved voice subscriber lines.

Configuring hunt group priority level

A priority level applies to the features of call waiting, call forwarding, and hunt group only.
By default, the priority levels for hunt group, call forwarding (excluding call forwarding unconditional),
and call waiting are 1, 2, and 3 respectively. The smaller the value is, the higher the priority level is.
When you change the priority level of a feature, make sure that different features have different
priority levels.
To configure a hunt group priority level:
Step
1. Enter system view.
2. Enter voice subscriber line
view.
3. Configure a priority level for
hunt group.
NOTE:
The call forwarding unconditional feature is free from the restriction of priority level. If the call
forwarding unconditional feature is enabled, the other types of call forwarding, call waiting, and hunt
group features will never take effect.
Configuration example
Telephone B and Telephone C have the same number, but Telephone B has a higher priority than
Telephone C (the POTS entity priority of Telephone B is configured in POTS voice view using the
priority command). Place a call from Telephone A to Telephone B and Telephone B is busy. In this
case, the hunt group service enables Telephone C to have a conversation with Telephone A.
# Enter voice subscriber line view.
<Sysname> system-view
[Sysname] subscriber-line 2/0
[Sysname-subscriber-line2/0] hunt-group enable
[Sysname-subscriber-line2/0] quit
# Enable the hunt group feature for the voice subscriber lines.
[Sysname] subscriber-line 2/1
[Sysname-subscriber-line2/1] hunt-group enable
Command
hunt-group enable
Command
system-view
subscriber-line line-number
hunt-group priority level
238
Remarks
Disabled by default.
Remarks
N/A
N/A
Optional.
1 by default.