Configuring Call Mode - HP FlexNetwork MSR Series Configuration Manual

However, the use of sequence numbers increases the required network bandwidth. Therefore,
determine whether to use sequence numbers based on actual conditions.
To configure VoFR packets to carry a sequence number:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter VoFR entity view.
5. Configure a match template
for the VoFR entity.
6. Configure the VoFR packets
sent by the local voice
gateway to carry a sequence
number.
Configuring FRF.11 trunk mode
Configuration prerequisites
Before configuring the FRF.11 trunk mode, complete the following tasks:
•
Configure POTS entities.
•
Configure VoFR entities.
•
Keep the codecs consistent at both sides.

Configuring call mode

Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter VoFR entity view.
5. Configure a call mode.
6. Configure a channel to the
peer voice gateway.
Configuring PSTN-dialed number
Step
1. Enter system view.
Command
system-view
voice-setup
dial-program
entity entity-number vofr
match-template match-string
seq-number
Command
system-view
voice-setup
dial-program
entity entity-number vofr
call-mode static
address vofr-static serial
interface-number dlci-number
cid-number
Command
system-view
318
Remarks
N/A
N/A
N/A
N/A
By default, no match template is
configured for the VoFR entity.
By default, the VoFR packets sent
by the local voice gateway do not
carry any sequence number.
Remarks
N/A
N/A
N/A
N/A
By default, the dynamic mode is
adopted.
By default, no channel to the peer
voice gateway is configured.
Remarks
N/A