Configuring Call Match Rules - HP FlexNetwork MSR Series Configuration Manual

[TG-voice-group-1] keepalive options
[TG-voice-group-1] hot-swap enable
[TG-voice-group-1] quit
[TG-voice] sip
[TG-voice-sip] redundancy mode parking
Other configurations on the SIP trunk device and other devices are the same as those described in
"Configuration
Configuration verification
1. When the SIP server with IP address 10.1.1.2 fails, the SIP server with IP address 10.1.1.3
takes over communications between the private network and the public network. After that, the
communications recover.
2. After the SIP server with IP address 10.1.1.2 recovers, it does not take over call processing and
the current SIP server with IP address 10.1.1.3 keeps working.

Configuring call match rules

Network requirements
As shown in
and Router A2 are private network devices, and Router B is a public network device. Users
connected to Router A2 are not allowed to call public network users. All calls between the private
network and public network are made through the SIP trunk device.
Figure 64 Network diagram
Configuration procedure
# Configure the call route for the outbound calls from private network user 2000 to public network
user 1000 by binding SIP server group 1 to VoIP voice entity 1.
<TG> system-view
[TG] voice-setup
[TG-voice] sip-trunk enable
[TG-voice] dial-program
[TG-voice-dial] entity 1 voip
[TG-voice-dial-entity1] address sip server-group 1
[TG-voice-dial-entity1] bind sip-trunk account 1
[TG-voice-dial-entity1] match-template 1000
procedure."
Figure 64, the enterprise private network has a SIP trunk device deployed. Router A1
214