Enabling And Disabling Call Waiting By Using Keys - HP FlexNetwork MSR Series Configuration Manual

Enabling and disabling call waiting by using keys

The device allows you to configure call waiting for FXS voice subscriber lines through telephones.
The call waiting configuration made on a telephone is also valid for the device. For example, after
you enable call waiting on a telephone, you can view the operation result by using the display this
command in corresponding voice subscriber line view.
To enable and disable the call waiting feature:
Enable keys
*58#
Configuring call waiting by using command lines
Enabling call waiting
In addition to being enable or disable the call waiting feature, you can set parameters related to this
feature. These parameters include the number of times a call waiting tone pattern is played, the
number of tones in a call waiting tone pattern, and the interval for playing a call waiting tone pattern.
To enable call waiting:
Step
1. Enter system view.
2. Enter voice subscriber
line view.
3. Enable call waiting.
4. Configure call waiting
tone parameters.
Configuring a call waiting priority level
A priority level applies to the features of call waiting, call forwarding, and hunt group only.
By default, the priority levels for hunt group, call forwarding, and calling waiting are 1, 2, and 3
respectively. The smaller the value is, the higher the priority level is. When you change the priority
level of a feature, make sure that different features have different priority levels.
To configure a call waiting priority level:
Step
1. Enter system view.
2. Enter voice subscriber line
view.
3. Configure a priority level for
call waiting.
Disable keys
#58#
Command
system-view
subscriber-line line-number
call-waiting enable
call-waiting { cwi-count
number | cwi-duration length |
cwi-interval length }
Command
system-view
subscriber-line line-number
call-waiting priority level
231
Remarks
N/A
N/A
Disabled by default.
Optional.
By default, a call waiting tone pattern is
played once, a call waiting tone pattern
contains two tones, and if the value of
cwi-count number is greater than 1 the
interval for playing a call waiting tone
pattern is 15 seconds.
Remarks
N/A
N/A
Optional.
The default is 3.