HP FlexNetwork MSR Series Configuration Manual page 347

•
If you want to prohibit users from making calls when their account balance in the RADIUS
server which is a comprehensive access management server (CAMS) is 0, and allow them to
make calls when there is sufficient account balance, configure the authentication, authorization,
and accounting functions on the voice gateway. This rule applies to one-stage dialing users and
two-stage dialing users.
•
Calls will be released in the case of an accounting failure.
Configuration prerequisites
A voice interface card (for example, an FXS interface card) is inserted in the router.
Configuration procedure
To enable the accounting function for one-stage dialing users:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice AAA client view.
4. Enable the accounting function
for one-stage dialing users.
Enabling authentication function for one-stage dialing users
For one-stage dialing users, there is no access number. It is impossible to enable the authentication
function for an individual user according to the identification. Therefore, the authentication function
can only be enabled for all one-stage dialing users.
Before enabling the authentication function, make sure that the RADIUS server and RADIUS client
(voice gateway) can communicate with each other at the network layer and that a list of one-stage
dialing users as well as authentication policies has been configured on the RADIUS server.
Configuration prerequisites
A voice interface card (for example, an FXS interface card) is inserted in the router.
Configuration procedure
To enable the authentication function for one-stage dialing users:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice AAA client view.
4. Enable the authentication function for
one-stage dialing users.
Enabling authorization function for one-stage dialing users
Similar to the authentication function, it is impossible to enable the authorization function for an
individual one-stage dialing user according to the identification because there is no access number.
Therefore, the authorization function can only be enabled, if necessary, for all one-stage dialing
users.
Command
system-view
voice-setup
aaa-client
accounting-did
Command
system-view
voice-setup
aaa-client
authentication-did
334
Remarks
N/A
N/A
N/A
Disabled by default.
Remarks
N/A
N/A
N/A
Disabled by default.