Enabling Security Calling - HP FlexNetwork MSR Series Configuration Manual

After the GK Client (router) is configured with the registration password, the password is carried
during the whole registration process.
Configuration prerequisites
Complete the required basic H.323 gateway configurations except for the ras-on command. (This
command is used for initiating registration requests to the gatekeeper after all configurations are
completed.)
Configuration procedure
To configure a registration password:
Step
1. Enter system view.
2. Enter voice view.
3. Enter gateway view.
4. Configure a gateway
registration password.

Enabling security calling

To let the gateway pass call tokens from the gatekeeper, configure security calling.
After a call is originated, the originating gateway obtains a call token from the originating gatekeeper
and transparently transmits it to the terminating gateway which will then pass the token to the
terminating gatekeeper. Tokens can be synchronized among gatekeepers. The terminating
gatekeeper can return the call accept message to the terminating gateway only after it accepts the
token.
Configuration prerequisites
Complete the required basic H.323 gateway configurations except for the ras-on command. (This
command is used for initiating registration requests to the gatekeeper after all configurations are
completed.)
Configuration procedure
To enable security calling:
Step
1. Enter system view.
2. Enter voice view.
3. Enter gateway view.
4. Enable security calling.
NOTE:
Security calling must be disabled in a voice network where the terminating gatekeeper has no ability
to process a call token.
Command
system-view
voice-setup
gk-client
gk-security register-pwd
{ cipher | simple } password
Command
system-view
voice-setup
gk-client
gk-security call enable
223
Remarks
N/A
N/A
N/A
No registration password is
configured by default.
Remarks
N/A
N/A
N/A
Enabled by default.