Associating The E1/T1 Interface With The Call Watch Group - HP FlexNetwork MSR Series Configuration Manual

Step
2. Create a rule in a call
watch group.

Associating the E1/T1 interface with the call watch group

To adapt the state of an E1/T1 interface to the state of the monitored local links in a call watch group,
you must associate the E1/T1 interface with the call watch group. Note that, each E1/T1 interface
can be associated with only one monitor group.
To associate the E1/T1 interface with the call watch group:
Step
1. Enter system view.
2. Enter E1/T1 interface view.
3. Associate the interface with the
call watch group.
Displaying and maintaining call watch
Task
Display information about the call
watch groups associated with E1/T1
interfaces.
Call-watch configuration examples
This section provides call-watch configuration examples.
Monitoring local interfaces
Network requirements
As shown in
an E1 link to the PBX to which Router A is connected to provide VoIP communication between
Router A and Router B in normal cases.
To enable device Voice A to disable interface E1 1/0 from routing calls destined for Router B when
interfaces Ethernet 1/1 and Ethernet 1/2 go down so that the PBX can immediately switch to a
backup link, do the following:
Command
•
•
Figure 86, device Voice A is connected through two local links to Router B and through
Specify a local interface in the rule
call-watch rule watch-number local
interface interface-type
interface-number
Specify a track object ID in the rule
call-watch rule watch-number
remote track track-entry-number
Command
system-view
controller controller-type number
•
In hard mode:
call-watch group watch-number hard
•
In soft mode:
call-watch group watch-number soft
Command
display call-watch status [ controller
controller-type controller-number ] [ |
{ begin | exclude | include }
regular-expression ]
266
Remarks
Use either command.
To create multiple rules in the
call watch group, repeat the
step.
Remarks
N/A
N/A
Use either
command.
Remarks
Available in any
view.