HP FlexNetwork MSR Series Configuration Manual page 350

Configuration procedure
To configure a two-stage dialing process:
Step
1. Enter system view.
2. Enter voice view.
3. Enter dial program view.
4. Enter access number view.
5. Configure a two-stage
dialing process.
Enabling accounting function for two-stage dialing users
After configuring access numbers, you can enable the RADIUS accounting function for two-stage
dialing users. Before enabling the accounting function, make sure that the RADIUS server and the
RADIUS client (voice gateway) can communicate with each other at the network layer and that a list
of corresponding two-stage dialing users as well as accounting policies has been configured on the
RADIUS server.
Calls will be released in case of an accounting failure.
Configuration prerequisites
You have configured an access number.
Configuration procedure
To enable the accounting function for two-stage dialing users:
Step
1. Enter system view.
2. Enter voice view.
3. Enter dial program view.
4. Enter access number view.
5. Enable the accounting
function for two-stage dialing
users.
Enabling the authentication function for two-stage dialing
users
After configuring access numbers, you can enable the RADIUS authentication function for two-stage
dialing users. Before enabling the authentication function, make sure the RADIUS server and the
RADIUS client can communicate with each other at the network layer, and that a list of
corresponding two-stage dialing users as well as authentication policies has been configured on the
RADIUS server.
The authentication function for two-stage dialing users is enabled for a specific access number, while
the authentication function for one-stage dialing users is enabled in voice AAA client view.
Command
system-view
voice-setup
dial-program
gw-access-number
access-number
process-config { callernumber |
cardnumber | voice-caller }
Command
system-view
voice-setup
dial-program
gw-access-number
access-number
accounting
337
Remarks
N/A
N/A
N/A
N/A
Caller number process with IVR
by default.
Remarks
N/A
N/A
N/A
N/A
Disabled by default.