Configuring Registrar Information For A Sip Ua - HP FlexNetwork MSR Series Configuration Manual

Configuring registrar information for a SIP UA

Configuration guidelines
The transport layer protocol specified in the registrar command must have been specified with the
listen transport command. Otherwise, no register request can be initiated.
If TLS is specified in the registrar command, you also need to configure the secure sockets layer
(SSL) policy name of the client with the crypto command. Otherwise, no register request can be
initiated.
You can use the registrar command only when the SIP registration function is disabled.
Configuration procedure
To configure registrar information for a SIP UA:
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP client view.
4. Configure the registrar
information for the SIP
UA.
Configuring proxy server information for a SIP UA
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP client view.
4. Configure the proxy server
information for the SIP UA.
Configuring registration timers
A voice entity or an SIP trunk account expires after it has registered with the registrar for a specified
period of time, which is the registration expiration interval.
Command
system-view
voice-setup
sip
registrar { dns domain-name | ipv4
ip-address } [ port port-number ]
[ expires seconds ] [ tcp | tls ]
[ scheme { sip | sips } ] [ slave ]
Command
system-view
voice-setup
sip
proxy { dns domain-name | ipv4
ip-address } [ port port-number ]
141
Remarks
N/A
N/A
N/A
By default, no registrar
information is configured for a SIP
UA.
If the domain name of the
registrar is specified, DNS lookup
will be performed as configured.
For more information, see
"Configuration procedure (3:
destination domain)."
Remarks
N/A
N/A
N/A
By default, no proxy server
information is configured for a SIP
UA.
If the domain name of the proxy
server is specified, DNS lookup
will be performed as configured.
For more information, see
"Configuration procedure (3:
destination domain)."