Configuring Basic R2 Signaling Parameters - HP FlexNetwork MSR Series Configuration Manual

Figure 22 ITU-T R2 interregister signaling exchange process
Originating side
Calling number: 123
Request calling party information (A-5)
Send calling accounting category 2 (II-7)
Request calling party information (A-5)
Request calling party information (A-5)
Request calling party information (A-5)
Request calling party information (A-5)
All digits are received completely (A-3)
Send calling service category 2 (II-2)
Subscriber idle and charging starts (B-6)

Configuring basic R2 signaling parameters

Configuring the country or region mode
Step
1. Enter system view.
2. Enter E1/T1 interface view.
3. Create a TS set and enable
R2 signaling for it.
4. Enter R2 CAS view.
5. Configure the country or
region mode.
Configuring the trunk direction for R2 signaling
Step
1. Enter system view.
2. Enter E1/T1 interface view.
Line signaling exchange
Send called number digit 7 (I-7)
Request next digit (A-1)
Send called number digit 8 (I-8)
Send calling number digit 1 (I-1)
Send calling number digit 2 (I-2)
Send calling number digit 3 (I-3)
Send number terminator (I-15)
Request next digit (A-1)
Send called number digit 8 (I-9)
Line signaling exchange
Command
system-view
controller { e1 | t1 } slot-number
timeslot-set ts-set-number
timeslot-list timeslots-list signal
r2
cas ts-set-number
mode zone-name
[ default-standard ]
Command
system-view
controller { e1 | t1 } slot-number
Terminating side
Called number 789
76
Remarks
N/A
N/A
N/A
N/A
Optional.
By default, the ITU-T mode is
adopted.
Remarks
N/A
N/A