Configuring The Call Authority Control - HP FlexNetwork MSR Series Configuration Manual

Configuring the call authority control

Network requirements
As shown in
for Department B are 5000 through 5999. The following restrictions need to be implemented:
•
Phones in Department A and Department B cannot originate external calls.
•
Phone 5000 is not allowed to originate calls to phone 1000.
Figure 55 Network diagram
Configuration procedure
1. Configure Router C:
# Configure the router to operate in the alone mode.
<RouterC> system-view
[RouterC] voice-setup
[RouterC-voice] sip-server
[RouterC-voice-server] server-bind ipv4 2.1.1.2
[RouterC-voice-server] server enable
# Configure authentication information for phones.
[RouterC-voice-server] register-user 1000
[RouterC-voice-server-user1000] number 1000
[RouterC-voice-server-user1000] authentication username 1000 password simple 1000
[RouterC-voice-server-user1000] quit
[RouterC-voice-server] register-user 1111
[RouterC-voice-server-user1111] number 1111
[RouterC-voice-server-user1111] authentication username 1111 password simple 1111
[RouterC-voice-server-user1111] quit
[RouterC-voice-server] register-user 5000
[RouterC-voice-server-user5000] number 5000
[RouterC-voice-server-user5000] authentication username 5000 password simple 5000
[RouterC-voice-server-user5000] quit
[RouterC-voice-server] register-user 5555
[RouterC-voice-server-user5555] number 5555
[RouterC-voice-server-user5555] authentication username 5555 password simple 5555
[RouterC-voice-server-user5555] quit
# Configure a call rule set.
[RouterC-voice-server] call-rule-set
[RouterC-voice-server-set] service 0
Figure 55, the DNs for Department A in a company are 1000 through 1999, while those
189