Configuring Signaling Parameters For Sip-To-Sip Connections - HP MSR SERIES Configuration Manual

Item
Codec Transcoding
Media Flow Mode
Delayed Offer to Early Offer
Configuring signaling parameters for SIP-to-SIP
connections
1. Select Voice Management > Call Route from the navigation tree.
2. Click the
The page for configuring SIP-to-SIP connection parameters appears.
icon of the call route to be configured.
Description
In the scenario where the SIP trunk device controls the results of
media capability negotiation, if the SIP trunk device cannot find a
common codec for two parties during negotiation, the two parties
fail to establish a call. In this case, you can select the Enable option
to enable codec transcoding on the SIP trunk device.
With this function enabled, the SIP trunk device uses its own codec
capability set to negotiate with the calling and called parties
respectively. If the negotiated codecs with the two parties do not
match, the SIP trunk device transcodes the media flows passing
through it.
By default, the Disable option is selected.
IMPORTANT:
The codec transcoding feature does not take effect in any of the
following cases:
•
Codec transcoding is enabled, but no DSP resources are
available for codec transcoding.
•
Codec transparent transfer is enabled.
•
Media flow-around is enabled.
Select the media flow mode:
•
Around—Enable the media packets to pass directly between two
SIP endpoints, without the intervention of the SIP trunk device.
The media packets flow around the SIP trunk device.
•
Relay—Specify the SIP trunk device to act as the RTP trunk proxy
to forward the media packets.
By default, the Relay option is selected.
•
Enable—Enable delayed offer to early offer (DO-EO) conversion
on the SIP trunk device.
•
Disable—Disable the DO-EO conversion on the SIP trunk device.
By default, the Disable option is selected.
594