HP FlexNetwork MSR Series Configuration Manual page 352

Step
4. Enter access number view.
5. Enable the authorization
function for two-stage dialing
users.
Configuring the method of collecting the digits of called
number
Use the callednumber receive-method command to configure the device to originate a call
immediately after all digits of a called number are collected or after a dial terminator # is collected.
The configuration applies to the card number/password process, caller number process, and caller
number process with IVR.
Configuration prerequisites
You have configured an access number.
Configuration procedure
To configure the method of collecting digits of a called number:
Step
1. Enter system view.
2. Enter voice view.
3. Enter dial program view.
4. Enter access number view.
5. Configure the method of
collecting digits of a called
number.
NOTE:
If a user first presses the dial terminator #, the device will ignore it and will not consider it as an error,
and the user can continue to dial a number. This rule applies to both card numbers and passwords.
Configuring the timeout interval between two digits for
two-stage dialing users
Configuration prerequisites
You have configured an access number.
Configuration procedure
To configure the timeout interval for a user to dial the next digit in a two-stage dialing process:
Step
1. Enter system view.
Command
gw-access-number
access-number
authorization
Command
system-view
voice-setup
dial-program
gw-access-number
access-number
callednumber receive-method
{ immediate | terminator }
Command
system-view
339
Remarks
N/A
Disabled by default.
Remarks
N/A
N/A
N/A
N/A
By default, users need to press
the dial terminator # after dialing
all digits of a called number.
Remarks
N/A