Configuration Procedure (1: Destination Ip Address) - HP FlexNetwork MSR Series Configuration Manual

Configuration procedure (1: destination IP address)

Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter VoIP entity view.
5. Configure the destination IP
address.
For more information about DNS, see HPE FlexNetwork MSR Router Series Comware 5 Layer 3—IP
Services Configuration Guide.
Configuration procedure (2: SIP proxy server)
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter VoIP entity view.
5. Enable the SIP proxy server.
Configuration procedure (3: destination domain)
If the destination address is a domain name, the device performs DNS lookup by using either of the
following modes:
•
Type-A—If you use the dns-type command to set the DNS lookup mode as a-record, or both
the domain name and destination port number are configured, the device uses the Type-A
mode to perform DNS lookup.
•
SRV—If the domain name is configured but the destination port number is not, use the
dns-type command to set the DNS lookup mode to SRV.
To configure SIP routing (3: destination domain):
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP client view.
Command
system-view
voice-setup
dial-program
entity entity-number voip
address sip ip ip-address [ port
port-number ]
Command
system-view
voice-setup
dial-program
entity entity-number voip
address sip proxy
Command
system-view
voice-setup
Sip
145
Remarks
N/A
N/A
N/A
N/A
Not configured by default.
Remarks
N/A
N/A
N/A
N/A
Not configured by default.
Remarks
N/A
N/A
N/A