Configuring A Call Route - HP FlexNetwork MSR Series Configuration Manual

Configuring a call route

Network requirements
As shown in
•
The internal numbers of a company are four-digit long and the area prefix is 8899.
•
External phone 55665000 attached to Router B is not registered with the local SIP server on
Router C.
•
Internal phone 1000 attached to Router A is already registered with Router C.
When a user in the company dials the external number, the local SIP server will route the call
according to the configured call-out route and add area prefix 8899 to the calling number.
Figure 57 Network diagram
Configuration procedure
1. Configure Router C:
# Configure the router to operate in the alone mode.
<RouterC> system-view
[RouterC] voice-setup
[RouterC-voice] sip-server
[RouterC-voice-server] server-bind ipv4 2.1.1.2
[RouterC-voice-server] server enable
# Configure a call route.
[RouterC-voice-server] call-route
[RouterC-voice-server-route] trunk 0 called-number 55665000 ipv4 2.1.1.1 area-prefix
8899
# Configure authentication information for Phone 1000.
[RouterC-voice-server] register-user 1000
[RouterC-voice-server-user1000] number 1000
[RouterC-voice-server-user1000] authentication username 1000 password simple 1000
2. Configure Router A:
# Configure voice entities.
<RouterA> system-view
[RouterA] voice-setup
[RouterA-voice] dial-program
[RouterA-voice-dial] entity 1000 pots
[RouterA-voice-dial-entity1000] match-template 1000
[RouterA-voice-dial-entity1000] line 2/0
[RouterA-voice-dial-entity1000] user 1000 password simple 1000
[RouterA-voice-dial-entity1000] quit
[RouterA-voice-dial]entity 55665000 voip
[RouterA-voice-dial-entity55665000] address sip proxy
[RouterA-voice-dial-entity55665000] match-template 55665000
[RouterA-voice-dial-entity55665000] quit
Figure 57:
193