Configuring The Local Sip Server To Operate In The Alive Mode (Method 1) - HP FlexNetwork MSR Series Configuration Manual

user
----------------------------------------------------------------------1000
1000
5000
Phone 1000 and Phone 5000 are successfully registered with the local SIP server Router C and
they can communicate with each other.
Configuring the local SIP server to operate in the alive mode
(method 1)
Network requirements
Router A and Router B carry out call services through VCX. To ensure the normal call services on
Router A and Router B when VCX fails, configure the local SIP server on Router C to operate in alive
mode, so that calls can be originated or received through Router C. See
Figure 53 Network diagram
Configuration procedure
1. Configure Router C:
# Configure the router to operate in the alive mode.
<RouterC> system-view
[RouterC] voice-setup
[RouterC-voice] sip-server
[RouterC-voice-server] server-bind ipv4 2.1.1.2
[RouterC-voice-server] mode alive-server
[RouterC-voice-server] probe remote-server ipv4 3.1.1.1
[RouterC-voice-server] server enable
# Configure number registration information for the phones.
[RouterC-voice-server] register-user 1000
[RouterC-voice-server-user1000] number 1000
[RouterC-voice-server-user1000] authentication username 1000 password simple 1000
[RouterC-voice-server-user1000] quit
[RouterC-voice-server] register-user 5000
[RouterC-voice-server-user5000] number 5000
[RouterC-voice-server-user5000] authentication username 5000 password simple 5000
2. Configure Router A:
# Configure voice entities.
<RouterA> system-view
number
5000
status
online 1.1.1.1:5060
online
185
address
2.1.1.1:5060
Figure 53.