Enabling The Sip Trunk Function - HP FlexNetwork MSR Series Configuration Manual

Hide thumbs Also See for FlexNetwork MSR Series:
Table of Contents

Advertisement

Task
Configuring call routes
for outbound calls
Configuring call routes for inbound calls
Enabling codec transparent transfer
Enabling media flow-around
Enabling delayed offer to early offer conversion
Enabling codec transcoding
Enabling address hiding
Enabling call forwarding
Enabling call transfer
Enabling midcall signaling pass-through

Enabling the SIP trunk function

Before using various SIP trunk functions, first enable the SIP trunk function on the SIP trunk device.
Do not use a device enabled with the SIP trunk function as a SIP UA.
To enable the SIP trunk function:
Step
1.
Enter system view.
2.
Enter voice view.
3.
Enable the SIP trunk
function.
Configuring a SIP server group
This section covers the procedures for creating and configuring a SIP server group.
Creating a SIP server group
Use SIP server groups to manage the registrar and call servers. A SIP server group can be
configured with up to five member servers. An index represents the priority of a member server in a
SIP server group. The smaller the index value, the higher the priority. The currently used SIP server
is called the current server. Each server in the SIP server group can be the current server, but there
is only one current server at a time.
To create a SIP server group:
Binding a SIP server group to the VoIP voice
entity
Specifying the destination address
Specifying the proxy server used for
outbound calls
Configuring call match rules
Command
system-view
voice-setup
sip-trunk enable
198
Remarks
Use one of the three methods.
Optional.
Required.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Remarks
N/A
N/A
Disabled by default.

Advertisement

Table of Contents
loading

Table of Contents