Configuring Tcp To Carry Outgoing Sip Calls - HP FlexNetwork MSR Series Configuration Manual

[RouterA-voice-dial] entity 1111 pots
[RouterA-voice-dial-entity1111] line 1/0
[RouterA-voice-dial-entity1111] match-template 1111
[RouterA-voice-dial-entity1111] quit
[RouterA-voice-dial] quit
[RouterA-voice] quit
# Disable the calling voice subscriber line from sending the calling number to the remote end.
[RouterA] subscriber-line 1/0
[RouterA-subscriber-line1/0] undo cid send
[RouterA-subscriber-line1/0] quit
# Configure the P-Asserted-Identity header field.
[RouterA] voice-setup
[RouterA-voice] sip
[RouterA-voice-sip] privacy asserted
2. Configure Router B:
# Configure the IP address of the Ethernet interface.
<RouterB> system-view
[RouterB] interface ethernet 2/1
[RouterB-Ethernet2/1] ip address 192.168.2.2 255.255.255.0
[RouterB-Ethernet2/1] quit
# Configure the voice entity.
[RouterB] voice-setup
[RouterB-voice] dial-program
[RouterB-voice-dial] entity 2222 pots
[RouterB-voice-dial-entity2222] line 1/0
[RouterB-voice-dial-entity2222] match-template 2222
[RouterA-voice-dial] entity 1111 voip
[RouterA-voice-dial-entity1111] address sip ip 192.168.2.1
[RouterA-voice-dial-entity1111] match-template 1111
Configuration verification
When telephone 1111 calls telephone 2222, the calling number 1111 will not be displayed on
telephone 2222.

Configuring TCP to carry outgoing SIP calls

Network requirements
Two routers Router A and Router B work as SIP UAs. It is required that the SIP calls from Telephone
1111 to telephone 2222 be carried over TCP.
Figure 47 Network diagram
167