Feature Configuration - HP FlexNetwork MSR Series Configuration Manual

Step
2. Enter voice view.
3. Enter SIP server view.
4. Enter call route view.
5. Configure a call route.
Displaying and maintaining the SIP local survival

feature configuration

Task
Display information of a
registered user or all registered
users.
Display the server resource
information.
SIP local survival feature configuration examples
This section provides configuration examples for SIP local survival.
Configuring the local SIP server to operate in the alone mode
Network requirements
Configure the local SIP server on Router C to operate in alone mode so that the phones register with,
and can make and receive calls through, the local SIP server. See
Figure 52 Network diagram
Configuration procedure
1. Configure Router C:
# Configure the router to operate in the alone mode.
<RouterC> system-view
[RouterC] voice-setup
[RouterC-voice] sip-server
[RouterC-voice-server] server-bind ipv4 2.1.1.2
[RouterC-voice-server] server enable
Command
voice-setup
sip-server
call-route
trunk tag called-number called-pattern
ipv4 dest-ip-addr [ port port-number ]
[ area-prefix prefix ]
Command
display voice sip-server
register-user { tag | all } [ |
{ begin | exclude | include }
regular-expression ]
display voice sip-server
resource-statistic [ | { begin |
exclude | include }
regular-expression ]
183
Remarks
N/A
N/A
N/A
By default, no call route is
configured.
Remarks
Available in any view.
Figure 52.