HP FlexNetwork MSR Series Configuration Manual page 281

Hide thumbs Also See for FlexNetwork MSR Series:
Table of Contents

Advertisement

Figure 87 Network diagram
Configuration procedure
1.
Configure device Voice A:
# Enable NQA server, configure two NQA test groups to monitor remote IP addresses 10.1.1.2
and 10.1.2.2, and associate the NQA test groups each with a track object.
<VoiceA> system-view
[VoiceA] nqa server enable
[VoiceA] nqa entry admin test1
[VoiceA-nqa-admin-test1] type icmp-echo
[VoiceA-nqa-admin-test1-icmp-echo] destination ip 10.1.1.2
[VoiceA-nqa-admin-test1-icmp-echo] frequency 1000
[VoiceA-nqa-admin-test1-icmp-echo] probe timeout 1000
[VoiceA-nqa-admin-test1-icmp-echo] reaction 1 checked-element probe-fail
threshold-type consecutive 1 action-type trigger-only
[VoiceA-nqa-admin-test1-icmp-echo] quit
[VoiceA] track 1 nqa entry admin test1 reaction 1
[VoiceA] nqa schedule admin test1 start-time now lifetime forever
[VoiceA] nqa entry admin test2
[VoiceA-nqa-admin-test2] type icmp-echo
[VoiceA-nqa-admin-test2-icmp-echo] destination ip 10.1.2.2
[VoiceA-nqa-admin-test2-icmp-echo] frequency 1000
[VoiceA-nqa-admin-test2-icmp-echo] probe timeout 1000
[VoiceA-nqa-admin-test2-icmp-echo] reaction 1 checked-element probe-fail
threshold-type consecutive 1 action-type trigger-only
[VoiceA-nqa-admin-test2-icmp-echo] quit
[VoiceA] track 2 nqa entry admin test2 reaction 1
[VoiceA] nqa schedule admin test2 start-time now lifetime forever
# Create call watch group 1, referencing the track object IDs.
[VoiceA] call-watch rule 1 remote track 1
[VoiceA] call-watch rule 1 remote track 2
# Associate interface E1 1/0 with call watch group 1 in soft mode.
[VoiceA] controller e1 1/0
[VoiceA-E1 1/0] call-watch group 1 soft
268

Advertisement

Table of Contents
loading

Table of Contents