HP FlexNetwork MSR Series Configuration Manual page 192

Step
5. Configure the IP
address of the local
SIP server as the IP
address of a local
interface.
6. Enable the local SIP
server.
To configure the alive mode:
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP server
view.
4. Configure the local
SIP server to operate
in the alive mode.
5. Set the local SIP
server address to the
IP address of an
interface on the local
router.
6. Configure the
keepalive probe.
Command
server-bind ipv4 ipv4-address
[ port port-number ] [ expires
time-interval ]
server enable
Command
system-view
voice-setup
sip-server
mode alive-server
server-bind ipv4 ipv4-address
[ port port-number ] [ expires
time-interval ]
probe remote-server ipv4
ipv4-address [ port port-number ]
[ keepalive time-interval ]
179
Remarks
By default, no IP address is configured,
that is, there is no local SIP server.
Note that the ipv4-address argument
can be the IP address of an interface on
the local router, or a loopback address
such as 127.0.0.1. Because the local
SIP server cannot accept registrations
from users when the server IP address
is set to 127.0.0.1, the IP address of an
interface on the local router is
recommended.
You can configure this command only
when the local SIP server is disabled.
By default, the local SIP server is
disabled.
The functions of the local SIP server can
take effect after you execute this
command.
Remarks
N/A
N/A
N/A
By default, the local SIP server operates
in the alone mode.
Note that you can change the operation
mode of the local SIP server only when
the local SIP server is disabled.
By default, no IP address is bound, that
is, there is no local SIP server.
Note that the ipv4-address argument
can be the IP address of an interface on
the local router, or a loopback address
such as 127.0.0.1. Because the local
SIP server cannot accept registrations
from users when the server IP address
is set to 127.0.0.1, the IP address of an
interface on the local router is
recommended.
You can configure this command only
when the local SIP server is disabled.
Optional.
By default, the keepalive probe is not
configured.
This command is valid only when the
local SIP server operates in the alive
mode, and can be configured only when
the local SIP server is disabled.