Enabling Vad; Configuring Options Related To Dial Plan; Configuring The Jitter Buffer - HP FlexNetwork MSR Series Configuration Manual

Step
7. Configure the out-of-band
DTMF transmission.

Enabling VAD

Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Create a VoIP voice entity
and enter VoIP voice entity
view.
5. Enable VAD.

Configuring options related to dial plan

Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Create a VoIP voice entity
and enter VoIP voice entity
view.
5. Configure calling numbers
permitted to originate calls to
the local voice entity.
6. Configure the priority of the
VoIP voice entity.
For more information about the above commands, see "Configuring dial plans."

Configuring the jitter buffer

Step
1. Enter system view.
Command
outband { h225 | h245 }
Command
system-view
voice-setup
dial-program
entity entity-number voip
vad-on
Command
system-view
voice-setup
dial-program
entity entity-number voip
caller-permit calling-string
priority priority-order
Command
system-view
19
Remarks
Optional.
Inband transmission by default.
Remarks
N/A
N/A
N/A
N/A
Optional.
Disabled by default.
Note that the G.711 codec does
not support VAD.
Remarks
N/A
N/A
N/A
N/A
Optional.
By default, no calling number is
configured, that is, incoming calls
are not restricted.
Optional.
By default, the priority level is 0.
The smaller the number, the
higher the priority.
Remarks
N/A