Configuring An Interface To Receive Calls - HP MSR Router Series Wan Access Configuration Manual

Step
5. Return to system view.
6. Enter physical interface view.
7. Assign the physical interface
to the specified dialer circular
group.
8. Configure the priority of the
physical interface in the dialer
circular group.

Configuring an interface to receive calls

To configure an interface to receive calls, you only need to enable DDR on the interface. You do not need
to configure dial strings. For the receiving interface to authenticate the caller, configure the dialer route
ip next-hop-address user hostname command. If the IP address and host name of the caller match the
configured ones, the receiving interface accepts the call. Otherwise, it rejects the call.
When you configure an interface to receive calls, follow these guidelines:
To configure one interface to place calls, you can perform the configuration on the physical
•
interface or through a dialer circular group.
To configure multiple interfaces to place calls, you can perform the configuration only through a
•
dialer circular group.
To configure an interface to receive calls directly on a physical interface:
Step
1. Enter system view.
2. Enter physical interface view.
3. Enable traditional DDR on the
interface.
Command
quit
interface interface-type
interface-number
dialer circular group number
dialer priority priority
Command
system-view
interface interface-type
interface-number
dialer circular enable
179
Remarks
N/A
N/A
By default, a physical interface
does not belong to any dialer
circular group.
Make sure the number arguments
in the interface dialer and dialer
circular group commands use the
same value.
The default setting is 1.
To configure one interface to place
calls, you do not need to configure
this command. To configure
multiple interfaces to place calls,
you need to configure this
command. Each time a call is
placed, the highest-priority
physical interface available is
selected. If a physical interface
with same-priority interfaces is
selected, the same-priority
interfaces are selected when they
are the highest-priority physical
interfaces available.
Remarks
N/A
N/A
By default, traditional DDR is
disabled on an interface.