Configuring A Number Sending Mode; Configuration Prerequisites; Configuration Procedure; Configuring A Dial Prefix - HP FlexNetwork MSR Series Configuration Manual

Configuring a number sending mode

Configure a number sending mode to control how the originating gateway sends a called number.
Three number sending modes are available:
•
Send the least significant digits (configured by the send-number digit-number command) of a
called number.
•
Sends all digits of a called number.
•
Send a truncated called number. When the match-template command configured for a voice
entity contains an ending wildcard, only the digits that match the wildcard are sent.

Configuration prerequisites

The required basic configurations have been completed on POTS entities.

Configuration procedure

To configure a number sending mode:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter POTS voice entity
view.
5. Configure a number sending
mode.
6. Bind a number template to
the local voice entity.

Configuring a dial prefix

The following section provides information about configuring a dial prefix.
Configuration prerequisites
The required basic functions have completed on POTS and VoIP entities.
Configuration procedure
You can configure a prefix for dialed PSTN numbers. When a POTS entity originates a call, the dial
prefix will be added to the called number.
To configure a dial prefix:
Command
system-view
voice-setup
dial-program
entity entity-number pots
send-number { digit-number | all
| truncate }
match-template match-string
119
Remarks
N/A
N/A
N/A
N/A
By default, the truncate mode is
used.
By default, no number template is
bound to the local or trunk voice
subscriber line.