Configuration Example Of Voice Entity Type Selection Priority Rules - HP FlexNetwork MSR Series Configuration Manual

Configuration example of voice entity type selection priority
rules
There are an IP connection and a PRI connection between Router A and Router B.
following describe the configurations for different voice entity type selection priority rules on Router A
and Router B.
Figure 30 Network diagram
1. Configure Router A:
# Configure PRI signaling.
<RouterA> system-view
[RouterA] controller E1 5/0
[RouterA-E1 5/0] pri-set
[RouterA-E1 5/0] quit
[RouterA] interface Serial 5/0:15
[RouterA-Serial5/0:15] isdn protocol-mode network
[RouterA-E1 5/0] quit
[RouterA] voice-setup
[RouterA-voice] dial-program
# Configure POTS entity 1000 and POTS entity 1001.
[RouterA-voice-dial] entity 1000 pots
[RouterA-voice-dial-entity1000] match-template 10001234$
[RouterA-voice-dial-entity1000] line 1/0
[RouterA-voice-dial-entity1000] quit
[RouterA-voice-dial] entity1001 pots
[RouterA-voice-dial-entity1001] match-template 20001234$
[RouterA-voice-dial-entity1001] line 5/0:15
[RouterA-voice-dial-entity1001] send-number all
[RouterA-voice-dial-entity1001] quit
# Configure VoIP entity 2000.
[RouterA-voice-dial] entity 2000 voip
[RouterA-voice-dial-entity2000] match-template 20001234$
[RouterA-voice-dial-entity2000] address sip ip 1.1.1.2
2. Configure Router B:
# Configure PRI signaling.
<RouterB> system-view
[RouterB] controller E1 5/0
[RouterB-E1 5/0] pri-set
[RouterB-E1 5/0] quit
[RouterB] voice-setup
[RouterB-voice] dial-program
# Configure POTS entity 2000.
111
Figure 30
and the