Configuring Transmit Energy Level Of Gateway Carrier - HP FlexNetwork MSR Series Configuration Manual

NOTE:
When the local training mode is adopted, use the fax local-train threshold command to configure
the threshold in percentage. When the PPP training mode is adopted, the gateway does not
participate in rate training and the threshold of local training is not applicable.

Configuring transmit energy level of gateway carrier

Usually, the default transmit energy level of the gateway carrier is acceptable. If the fax cannot be set
up yet on the premise that other configurations are correct, you can attempt to adjust the transmit
energy level of the gateway carrier (that is, transmit energy level attenuation). A greater level
indicates greater energy. A smaller level indicates greater attenuation.
Configuration prerequisites
VoIP configuration is completed, IP calls can be made successfully, and fax machines are connected
correctly.
Configuration procedure
To configure the transmit energy level of the gateway carrier:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter voice entity view.
5. Configure the transmit
energy level of the gateway
carrier.
Configuring T.38 faculty description compatibility
Configuration prerequisites
VoIP configuration is completed, IP calls can be made successfully, and fax machines are connected
correctly.
Configuration procedure
To configure the T.38 faculty description compatibility:
Step
1. Enter system view.
2. Enter voice view.
3. Configure the faculty set of the
voice gateway in H.323 slow
connection to contain T.38
faculty description..
Command
system-view
voice-setup
dial-program
entity entity-number { pots |
vofr | voip }
fax level level
Command
system-view
voice-setup
voip h323-conf tcs-t38
278
Remarks
N/A
N/A
N/A
N/A
By default, the transmit energy level
of the gateway carrier is –15 dBm.
Remarks
N/A
N/A
By default, the faculty set contains
T.38 faculty description.