Configuring Call Authority Control - HP FlexNetwork MSR Series Configuration Manual

Step
4. Specify a trusted node.

Configuring call authority control

This section describes how to configure call authority control.
Configuring a call rule
The local SIP server supports the call authority control feature. Define different call rules and apply
them in different views to control the call authorities of users within the jurisdiction.
To configure a call rule:
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP server view.
4. Enter call rule set view.
5. Create a call rule and enter
call rule view.
6. Configure a call rule.
Applying a call rule set
You can use the srs command to apply a call rule set in SIP server view or register user view.
When different call rule sets are applied in SIP server view, register user view of the calling user, and
register user view of the called user, the local SIP server first processes the call rule set applied in
SIP server view, then the one applied in register user view of the calling user, and finally the one
applied in register user view of the called user.
To apply a call rule set:
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP server view.
4. Apply a call rule set in SIP
server view.
To apply a call rule set in register user view:
Command
trusted-point ipv4 ipv4-address
[ port port-number ]
Command
system-view
voice-setup
sip-server
call-rule-set
service tag
rule tag { deny | permit }
{ incoming | outgoing } { pattern
| any }
Command
system-view
voice-setup
sip-server
srs tag
181
Remarks
By default, no trusted node is
specified.
Remarks
N/A
N/A
N/A
N/A
N/A
By default, no call rule is
configured.
You can configure up to 32 call
rules.
Remarks
N/A
N/A
N/A
By default, no call rule set is applied
in SIP server view.